THE NEW MK2 PARALLEL GUIDES – THE MK1 UPGRADE VERSION for Festool, Makita, Triton and Milwaukee. You must have the MK1 version for this to work. do not buy this option if you do not have a Benchdogs PG system
THE FULL MK2 VERSION SYSTEM CAN BE FOUND HERE
The new improved MK2 PG System has a number of upgrades, Precision Machines Aluminium Stops and new improved narrow cut is a one-time calibration for both parallel cuts and narrow cuts. The fence has a dual scale for both Parallel and Narrow cuts.
Set the stop on one side for parallel cuts or for Narrow Cut Rips, turn the stop 180 degrees and fit the narrow cut attachment to the underside of the stop then set the size needed and place the NCR attachment to the edge of the board allowing you to produce repeatable precise cuts.
Our precision machined parallel guide system is compatible with Festool, Makita and Triton tracks and is a simple system to connect. Slide in and tighten the thumbscrews, set your stop and away you go.
Available in Metric or Imperial
330 Sections can achieve cuts of the following
Section 1 – 520mm
With Sections 1 & 2 – 850mm
With All Sections – 1180mm
445 Sections can achieve cuts of the following
Section 1 – 690mm
With All Sections – 1180mm
You will receive: 330mm (1180mm Maximum Length)
1 x Set / pair – Rails (6x 330mm)
2 x Aluminium Stops
2 x Stainless Steel Narrow Cut Attachments
You will receive: 500mm (1180mm Maximum Length)
1 x Set / pair – Rails (4x 500mm)
2 x Aluminium Stops
2 x Stainless Steel Narrow Cut Attachments
All markings on the tracks are laser engraved.
THE FULL VERSION OF THE SYSTEM CAN BE FOUND HERE
Calibration can easily be achieved by loosening 2 thumbscrews and moving to your cut line’s desired measurement.
Our new manual will be available soon
Reviews
There are no reviews yet.