Parallel Guide Extrusion – Mafell / Bosch GKT

The parallel guide extrusion is compatible with Mafell, Bosch & Bosch GKT Tracks. A simple system to connect. Slide in and tighten the thumbscrews, set your stop and away you go.

Please Note: You will need to add joiners if required.

The extrusions are available as either 6 x 330mm sections or 4 x 440mm sections

Available in Metric or Imperial

330 Sections can achieve cuts of the following

Section 1 -500mm
With Sections 1 & 2 – 830mm
With All Sections – 1160mm

445 Sections can achieve cuts of the following

Section 1 – 620mm
With All Sections – 1060mm

All markings on the tracks are laser engraved.

Calibration can easily be achieved by loosening two screws and moving to your cut line’s desired measurement.

THIS PRODUCT IS COMPATIBLE WITH BOSCH GKT PLUNGE SAWS